|
Author
|
Topic: setting up a switch
|
martness
Junior Member Posts: 14
From:england
Registered: Dec 2000
|
posted 12-03-2000 04:14 AM
   
Ive read the answer given about setting up a switch but i still cannot set up a switch to open a door,when i set them up as per the answer already given and using the manual the program crashes when i get lara to use the switch,can anybody help and please answer in plain english.
thanks.IP: Logged |
JohnCroft
Member Posts: 251
From:Germany
Registered: Nov 2000
|
posted 12-03-2000 05:09 AM
Hi!Simply click on the door ou want to open, then on the floor (!!) the switch is on, click the pink box to set a simple trigger.
Then click on the switch, click on the text next to the pink box, change the TYPE from TRIGGER to SWITCH and click on the floor again where the switch is on and then click the pink box. Easy, isnīt it?  IP: Logged |
martness
Junior Member Posts: 14
From:england
Registered: Dec 2000
|
posted 12-03-2000 06:18 AM
thanks I'll try that quote:
Originally posted by JohnCroft:
Hi!Simply click on the door ou want to open, then on the floor (!!) the switch is on, click the pink box to set a simple trigger.
Then click on the switch, click on the text next to the pink box, change the TYPE from TRIGGER to SWITCH and click on the floor again where the switch is on and then click the pink box. Easy, isnīt it?
IP: Logged |
Reb@Eidos
unregistered
|
posted 12-04-2000 09:41 AM
YOU MUST HAVE A TRIGGER FOR THE DOOR AND THE SWITCH and they have to be on the same floor square. If everything is set up right, when you click on the pink trigger square in the Plan View Grid you will cycle through yellow boxes that read 'Trigger for door_type4', 'lever_switch', and 'switch for lever_switch'. (The last is the trigger you change to the 'switch' setting.) If you don't see these three messages, you have probably left out a trigger.
IP: Logged |
Eidos Interactive Forums
UBBFriend: Email This Page to Someone! 
