|
Author
|
Topic: Problem With Doors
|
Joseph Seymour
Member Posts: 85
From:Oakland, Md, USA
Registered: Sep 1999
|
posted 12-13-2000 06:19 PM
   
I started useing switch to open door, but i can't get it right. The Door will not open, Is there any Information About getting this to work?IP: Logged |
Trocinth
Member Posts: 122
From:Bronx, New York, USA
Registered: Dec 2000
|
posted 12-13-2000 06:31 PM
The general procedure for making a switch open a door is as follows: First, place the door and switch on your map. Then, with FACE EDIT off, click on the switch. Now, click on the square directly beneath the switch (the square that the switch is sitting on, in other words), and press the pink trigger button. Now, click in the white box next to the trigger button on the left hand side of the interface. Set the trigger type to "SWITCH." Next, click on the door. Now, click on the square beneath the switch again (same square as before), and press the pink trigger button again. This time, however, do not set the trigger type. Certain doors must be positioned properly in order to open correctly. For example, DOOR TYPE 4 in the TUT.WAD should be placed in the room that the door is opening into. Others have certain height and width requirements. Getting it to work requires some trial and error, but the basic steps are always the same. IP: Logged | |
Eidos Interactive Forums
UBBFriend: Email This Page to Someone! 
