Posts: 12
From:Burnaby, B.C., Canada
Registered: Jan 2001

posted 01-21-2001 12:24 PM               

---

I've read the manual, and understand how to place objects. I have no problems placing any objects except the Flame Emitter_2. In the tutorial program, I'm trying to place the emitter on the end of the torches in the first room x. I cannot get them on the same plane as the torches! It will always appear inside the column I've attached the torch to, or it will appear below the torch on the ground (eg, the correct x,y coordinate, but too low on the z axis.) I've tried using Alt-Z to get a better angle for placement, but nothing helps. I can rotate the torch to get the correct orientation, but it's always on the wrong z axis. Please help!

------------------

IP: Logged

Posts: 102
From:Phoenix, Arizona, USA
Registered: Dec 2000

posted 01-21-2001 12:37 PM               

---

Select the item and use the Floor +/- buttons.

IP: Logged

Posts: 151
From:Netherlands
Registered: Dec 2000

posted 01-22-2001 01:45 PM               

---

Right clic on the flame emmitter or anything else. It will rotate.

IP: Logged

Posts: 12
From:Burnaby, B.C., Canada
Registered: Jan 2001

posted 01-22-2001 10:03 PM               

---

Thanks, guys. The floor+ did it. So obvious I could smack myself.

IP: Logged