|
Author
|
Topic: How would you make...
|
Almasy
Member Posts: 450
From:Boca Raton, FL, USA
Registered: Dec 2000
|
posted 02-02-2001 07:43 AM
  
... a very large waterfall. I know you can place 2 waterfalls in the Catacomb objects, but they aren't very long. I was hoping to make a waterfall like the "Coastal Village" and "Nevada Desert" levels in TR:III. If you remember, they had huge waterfalls that were much taller than the "Catacomb" ones... For now i can only make their small waterfalls. Is there a way to extend them? IP: Logged |
josemariamoreno
Member Posts: 38
From:Linares, Spain,
Registered: Jan 2001
|
posted 02-02-2001 08:03 AM
Sorry, you cannot enlarge the objects.
Good luck with your project.
IP: Logged |
Redwood Elf
Junior Member Posts: 24
From:Rohnert Park, California, USA
Registered: Jan 2001
|
posted 02-03-2001 10:05 AM
Try stacking rooms...place one waterfall directly above the other and see if that solves your problem..IP: Logged |
MichaelB
Member Posts: 217
From:
Registered: May 2000
|
posted 02-04-2001 07:18 PM
How about a 'cascade' waterfall made up of three or four or even five waterfall objects?------------------
How can I be dead already?  IP: Logged |
Jantje
Member Posts: 93
From:The Netherlands
Registered: May 99
|
posted 02-04-2001 11:35 PM
The Waterfalls in TR3 were created with textures...------------------
"Ahahahaha, right, in your next life!" Sophia Leigh (or is it Lee?)
IP: Logged |
Lara Severi
Member Posts: 937
From:Darlington, CO Durham, England
Registered: Jan 2001
|
posted 02-05-2001 01:24 AM
Download a texture file from TR3 and apply the waterfall texture (quater square shared with water textures) Then set the animation ranges to make the water move like a waterfall.IP: Logged |
Eidos Interactive Forums
UBBFriend: Email This Page to Someone! 
