|
Author
|
Topic: Waterfalls
|
Raider Nut
Member Posts: 88
From:Norwich
Registered: Dec 2000
|
posted 02-05-2001 01:45 PM
   
I am building a room with some water rooms off it, but when you first come into the room they are dry, and the water only appears when you throw a switch.I am using the Catacombs Wad and want to use the waterfalls, but when I place them they show without trigerring them, but I don't want them to show until I throw the switch. Can anyone help????? Carry on Creating. IP: Logged |
piega
Member Posts: 151
From:Netherlands
Registered: Dec 2000
|
posted 02-05-2001 01:52 PM
Its very simple, i used it in my catacomb towers level, select your waterfall, press O for the ocb and press invisible. It becomes visible after it is triggered.When your playing a level, your looking trough the eyes of the designer... IP: Logged |
Raider Nut
Member Posts: 88
From:Norwich
Registered: Dec 2000
|
posted 02-07-2001 10:24 AM
Cheers mate. Sometimes the seemingly impossible is not as impossible as it seems.
Should have been able to figure that out.
This Level Editing must have fried my brain.By the way, your level looks great, but I haven't got very far yet. Carry on Creating IP: Logged |
piega
Member Posts: 151
From:Netherlands
Registered: Dec 2000
|
posted 02-07-2001 01:21 PM
Thanks for the reply, i updated my level because there is a little mistake finishing the level earlyer. i think you have to wait a few days to get it again at tomb-custem...
I added a few graphics and lightning and the level is now as it should be...
Did you know you get waterfall sound wen you trigger a waterfallmist, make the cone face ofwards the waterfall to get it on the right side...good luckIP: Logged |
Raider Nut
Member Posts: 88
From:Norwich
Registered: Dec 2000
|
posted 02-07-2001 01:27 PM
I managed to get the waterfalls to work by doing what you said, looks much better now.
Thanks for the tip on sound I will give it a try. Carry on Creating
Mike
IP: Logged |
Eidos Interactive Forums
UBBFriend: Email This Page to Someone! 
