|
Author
|
Topic: Does anyone agree that.............
|
Stripix
Member Posts: 132
From:SF,California, USA
Registered: Mar 2001
|
posted 05-09-2001 10:33 PM
   
Does any agree that it is possible to rip tr1,tr2,tr3,tr5 wads? Because I know its not impossible.Greetz,
Stripix  [This message has been edited by Stripix (edited 05-09-2001).] IP: Logged |
blacknile
Member Posts: 103
From:Uphoria
Registered: Jan 2001
|
posted 05-09-2001 11:45 PM
how do you know that? IP: Logged |
jbc21
Member Posts: 123
From:Eilat, Israel
Registered: Feb 2001
|
posted 05-10-2001 04:05 AM
it's not entirely possible now but it might be pretty soon...
Some brains are among us...  JB IP: Logged |
Flash
Member Posts: 167
From:right from the blue skies
Registered: May 2001
|
posted 05-10-2001 05:06 AM
Yap, Michiel is currently working on WADmerger 1.7. With this program you can rip TR1-5 wads. You can also edit meshes with CAD program. I do think it will be soon finished.  )  ) IP: Logged |
robbase
Member Posts: 425
From:the other side of the puddle
Registered: Mar 2001
|
posted 05-10-2001 09:02 AM
from what I understood, the .wad format wasn't used untill TR.3 or 4. did I have this completly wrong?
 IP: Logged |
Stripix
Member Posts: 132
From:SF,California, USA
Registered: Mar 2001
|
posted 05-10-2001 05:09 PM
Well, I guess I just have to wait until wadmerger 1.7 comes out.
Can't wait.I just have to be patient.
Its too bad that TRviewer can't rip wads off the tr series.Greetz,
Stripix IP: Logged |
Eidos Interactive Forums
UBBFriend: Email This Page to Someone! 
