Posts: 665
From:England, Sheffield
Registered: Dec 2000

posted 06-04-2002 03:33 AM               

---

Sorry about the size

ok, This is a lava room right?. There is eventually going to be a 1 click high water room underneath the lava to give the lava effect more realness. The six squares to the right i can make into a water room easily. But what about the 2 half squares? How do i make the lava half squares a water room underneath and just leave the rock there? Whenever i try to add a water room underneath the half square it doesn't do it! Could you please tell me how to do it??????

IP: Logged

Posts: 1112
From:Valmiera, Latvia
Registered: Jan 2002

posted 06-04-2002 03:44 AM               

---

firstly make a room just as big as the one above, except the height that is only 1 click. Select the whole floor from the top room and press the 'door' button. then add Toggle Opacity 2 and 'no collision' as needed.

IP: Logged

Posts: 3624
From:Den Haag, The Netherlands
Registered: Apr 2001

posted 06-05-2002 04:27 AM               

---

you can select the whole room by pressing CTRL+Z

------------------
Peace is but a shadow of death, desperate to forget it's painful past...
Though we hope for promising years, after shedding a thousand tears, yesterday's sorrow constantly nears.
And while the moon still shines blue, by dawn, it will turn scarlet hue.

IP: Logged

Posts: 13
From:
Registered: Apr 2002

posted 06-05-2002 11:39 AM               

---

If you want the rock to look like it's sticking out of the Lava then go into the water room, and select the two squares in the corner under that rock and press the wall button. For the triangular bits you could create a slope into the water, by raising the entire half of that block to the top of the one click room and lowering the opposite corner by a click. It should look like the rock slopes into the lava, if you see what I mean...

IP: Logged