Posts: 1819
From:Omicron Theta science colony
Registered: May 2001

posted 06-20-2002 03:50 AM               

---

I am using the 'teeth spikes' and I wish to have them rise from the ground at timed intervals. I would like them to raise and then drop again, and after a couple of seconds, repeat. This would occur until an antitrigger.
Which OCB codes do I need and what timer reference should I use -No. or +No.?

Thank you for your assistance.

IP: Logged

Posts: 1248
From: yellaV of the sgniK, tpygE
Registered: Aug 2001

posted 06-20-2002 04:06 AM               

---

The OCB code for the spikes to raise and lower and raise and lower (from the ground) is 4. If you want them lowering from the ceiling, leave the OCB at 0. You can't change the time between the raise/lower processes however.

Here's the chart from the manual:

Vertical in Room Edit above view:

South: 0
South West: 1
West: 2
North West: 3
North: 4
North East: 5
East: 6
South East: 7

Horizontal in Room Edit above view:

South: 8
South West: 9
West: 10
North West: 11
North: 12
North East: 13
East: 14
South East: 15

Add 16 to make them come out and never retract. Add 32 to make them come out and then retract to never come out again.

IP: Logged

Posts: 1819
From:Omicron Theta science colony
Registered: May 2001

posted 06-20-2002 05:35 AM               

---

Thank you my friend.

IP: Logged

Posts: 1376
From:Millwaukee,Wi,USA
Registered: Jun 2001

posted 06-20-2002 08:03 AM               

---

Just to note that there was a tutorial in the TRLE FAQ and Community, which i find very useful

------------------
TRLE SEARCH ENGINE

IP: Logged